Nav Menu 3

  Home > Accessories >

80-Amp Pro Switch-Mode BEC Brushless ESC, EC5 (V2)

List Price: $99.99
Our Price: $99.99

Quantity in Stock:(Out of Stock)
Availability:: Usually Ships in 24 to 72 Hours
Product Code: EFLA1080B


   Up to 80 amps continuous current with proper air flow and 100 amps burst current (15 seconds)
   5V switch-mode BEC capable of 5 amps continuous current with 6 amps max burst on any recommended input voltage
   Drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage
   3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
   Programmable motor braking
   Safe power-arm mode prevents accidental starts
   Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
   Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
   Programmable soft start-up rate - .25 second or 1 second
   Auto motor shut down if signal is lost or there is interference
   Programmable timing—5 user-selectable ranges–use with a large variety of brushless motors
   Two operating modes–Airplane or Heli
   Pre-wired connectors—E-flite EC5 on battery input and 4.0mm female gold bullets on motor output leads


When performance matters in your high-current applications, look no further than the E-flite® 80-amp Pro switch-mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated switch-mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 80 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic end-caps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range and more, the E-flite 80-amp Pro switch-mode ESC is truly a ‘pro series’ electronic speed control.

This product is not intended for use by children under 14 years of age without direct adult supervision.

Have the original EFLA1080 ESC? CLICK HERE to see an important Product Bulletin.


Forward: Yes
Brake: Yes
Time Delay Brake: Yes
Continuous Maximum Current: 80A
Input Connector Types: EC5, 10AWG
Output Connector Types: 4mm gold bullet, 12AWG
Momentary Peak Current: 100A (15 seconds) Proper Cooling Required
Length: 3.0 in (77mm)
Width: 1.6 in (41mm)
Height: 0.62 in (15.5mm)
Weight: 3.75 oz (106 g)
BEC Voltage: 5.5 Volt switch-mode
Overload Protection: Yes
Wire Gauge: 10 awg input leads; 12 awg output leads
Cells w/BEC: 9- to 18-cell Ni-MH, 3–6S Li-Po
Auto Cutoff: Yes

Share your knowledge of this product. Be the first to write a review »